Q-Logic 5602 사용자 설명서
6 – Port Configuration
Port Binding
6-8
59183-01 A
S
You can configure all ports based a specified source port using the
Set Config Ports command. The following example configures ports 0–20 based
on port 3.
Set Config Ports command. The following example configures ports 0–20 based
on port 3.
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin) #> set config ports 3
.
.
.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
The following example temporarily changes the port 1 administrative state to
Down:
Down:
SANbox #> admin start
SANbox (admin) #> set port 1 state down
6.3
Port Binding
Port binding establishes up to 32 switches or devices that are permitted to log in to
a particular switch port. Switches or devices that are not among the 32 are
refused access to the port. Enter the
a particular switch port. Switches or devices that are not among the 32 are
refused access to the port. Enter the
command
to display the port binding configuration for all ports as shown in the following
example.
example.
SANbox #> show config security portbinding
Configuration Name: default
-------------------
Port Binding Status WWN
---- -------------- -----------------------
0 Enabled 10:20:30:40:50:60:70:80
1 Enabled 10:20:30:40:50:60:70:80
2 Disabled 10:20:30:40:50:60:70:80
3 Enabled 10:20:30:40:50:60:70:80
4 Enabled 10:20:30:40:50:60:70:80
5 Disabled 10:20:30:40:50:60:70:80
6 Enabled 10:20:30:40:50:60:70:81
7 Disabled 10:20:30:40:50:60:70:82
8 Enabled 10:20:30:40:50:60:70:80