Vanguard Managed Solutions 7300 Series 사용자 설명서
3-16
Vanguard 7300 Installation
Installing the Vanguard 7300 in a Rack
Procedure for
Rack-mounting
Rack-mounting
Figure 3-10 shows the mounting hardware locations on the flanges of the Vanguard
7310 Version 1. For the locations on the Vanguard 7330 Version 1, refer to
Figure 3-11, For the locations on the Vanguard 7310 and 7330 Version 1, refer to
Figure 3-12. Use standard rack-mounting hardware (not supplied) to secure the
chassis in the rack.
7310 Version 1. For the locations on the Vanguard 7330 Version 1, refer to
Figure 3-11, For the locations on the Vanguard 7310 and 7330 Version 1, refer to
Figure 3-12. Use standard rack-mounting hardware (not supplied) to secure the
chassis in the rack.
Version 1 Rack-
mounting
mounting
Use these steps for rack-mounting a 7310 and 7330 Version 1 Series router:
1) Remove the front covers. (See the “Removing And Replacing Vanguard 7300
2) Two people are required to position the chassis and slide it into the front of the
rack.
3) Attach the front of the chassis to the rack:
• Secure the Vanguard 7310 Version 1 with mounting hardware at four locations,
two on each side of the front panel (Figure 3-10)
• Secure the Vanguard 7330 Version 1 at eight locations, four on each side of the
front panel (Figure 3-11)
Figure 3-10. Rack Mount Hardware Locations - Vanguard 7310
POR
T 1
POR
T 2
ACT 100bT LINK
POR
T 1
POR
T 2
ACT 100bT LINK
EXT
PWR
ABT
RST
BFL
CPCI
USB 1
COM 1
10/100 BASE T
USB 0
CPU
PCI
PCI MEZZANINE CARD
POR
T 1
POR
T 2
ACT 100bT LINK
P
M
C
2
D
E
B
U
G
HO
T SW
AP
RESET
P
M
C
1
11
7
3
8
W
A
N
4
0
Univer
sal
Serial I/O
EXT
PWR