Printronix Integrated Network Interface Card 사용자 설명서

26 

If the Netmask does not match, complete the following steps:

a.

Take the printer offline.

b.

Using the control panel, modify the Gateway value to 
0.0.0.0. (non-configured).

c.

Place the printer online and wait until E-NET IS READY 
displays.

d.

Take the printer offline and enter the Gateway Address you 
desire.

e.

Place the printer online and wait until E-NET IS READY 
displays. This saves the new Gateway Address.

Your NIC is now configured and connected to your network.

NOTE: The Access Point must be configured according to the 

manufacturer's installation guide.

To configure Wireless NIC card, configure the ethernet and 
wireless IP addresses so they can be seen on the network. This 
includes several network-related settings (e.g., an IP address within 
TCP/IP environments) configured through the built-in command 
shell, npsh, or from the control panel.

NOTE: It is not necessary to configure the Ethernet IP address if 

only WLAN NIC is installed.

You can set the wireless NIC IP and other parameters from the 
front panel. Refer to the NETWORK SETUP menu in the User’s 
Manual for more information.