Printronix Integrated Network Interface Card 사용자 설명서

27

You need to set both the ethernet and wireless network IP 
addresses according to the TCP/IP environment that the printer is 
connected to. There are four parameters accessed from the printer 
control panel that are IP address related. These parameters are 
located in the "Ethernet Address" menu and the "Wireless Address" 
menu.

NOTE: It is not necessary to configure the Ethernet IP address if 

the WLAN NIC is not installed.

•

This is the host for IP addresses that have four segments. They are 
displayed as SEG1, SEG2, SEG3, and SEG4 which can be set to 
any value in the range of 0 to 255.

•

This is the subnet mask for the host IP that has four segments. 
They are displayed as SEG1, SEG2, SEG3, and SEG4 which can 
be set to any value in the range of of 0 to 255.

•

This is the gateway IP addresses that have four segments. They 
are displayed as SEG1, SEG2, SEG3, and SEG4 which can be set 
to any value in the range of 0 to 255.

•

The DHCP option allows you to obtain host server IP addresses 
when powering onto the network. The DHCP can be configured to:

•

Enable – each time you power on, the host server 

automatically assigns you a different address (if the IP address 
has not been previously assigned).

•

Disable – You choose the host server IP address. After the 

selection, the IP Address remains fixed even after you reboot.