TANDBERG D1320203 사용자 설명서

TANDBERG 3G Gateway 

                                                  Data port Command Interface User Guide

 

The commands can be divided into three major classes: 

•  Parameter Configuration Commands, Xconf. 
•  Status Commands, Xstat. 
•  User Commands, Xcom. 

Parameter Configuration Commands are commands that set a system parameter to a specific value. E.g.: The 
command Xconf telnet mode: "on" enables telnet access on the 3G Gateway. If the command is 
syntactically correct the 3G Gateway returns OK, otherwise the 3G Gateway returns ERROR. An example 
is shown below (the user input is shown in bold). 
 
Xconf telnet mode: "on" 
 
OK 

When issuing a Parameter Setting Command without a parameter, the 3G Gateway will return the command 
with the current setting. E.g.: 

*c xConfiguration Telnet Mode: On  

OK 

Status Commands are commands that list different sets of system parameters. Status commands are 
automatically called when corresponding parameters are being changed. 

User Commands are commands that allow users to configure operational parameters, like option keys, 
service and dial plan entry manipulations, disk operations and system reboot. 

The commands are divided into five groups: System Configuration Commands, General 3G Gateway 
Commands, System Status Commands, Debug Commands and Special Commands. 

D1320203       

                                                                                                                       8