Energizer FLEX8C 사용자 설명서

다운로드
페이지 69
 
39
The playback function uses all 4 switches. NOTE that you must be in the OFF 
state to re-enter the record mode. The REW and FWD switches have different 
meaning when in PLAY or PAUSE. Note that “playback” does not erase any 
data. Once you are finished with local “playback”, you may continue recording 
from where you left off by first turning the RECORDER “off” then pressing RCD.  
The HAWK8/A and FALCON4 do not have PLAYBACK capability. 
 
 
PLAY / PAUSE 
 
NOTE! 
 
The Play / PAUSE (P/P) as well as the REW(R) controls on the HAWK unit is 
on the bottom. Use a paper clip to operate and hold down button until 
recording plays (3-5 seconds). 
  
The "PLAY" button causes the unit to power up, turn the green LED 'ON" and 
start playing from the beginning Session 1. Depressing this switch while the unit 
is playing will cause it to PAUSE and flash the green LED. To continue playing 
you must depress this switch again. 
 
REW 
 
Depressing this switch while the audio is playing causes a 3-minute jump back. 
Depressing it while you are in PAUSE causes the RECORDER to begin playing 
from the beginning of the current Session. To jump back into the previous 
session you should hit REW from the PAUSE state, and then hit REW again to 
take you back into the previous session. 
 
FWD     
   
Depressing the "FWD" switch causes the audio to jump ahead 3 minutes. If you are in 
the PAUSE state, depressing this switch will jump you into the beginning of the next 
Session.
    
 
 
OFF 
 
Depressing this button will cause the recorded to be powered OFF. This must be 
done to re-enter the RECORD mode
 
 
RECORDING LENGTH 
 
Type of camera and frames per second determines the recording length.  The 
chart below displays HAWK recording duration.  The settings are stereo with 2:1 
compression.  Times are given for each session and full recorder length.