JVC LPT1100-001A 사용자 설명서
Masterpage:Right+
83
Filename [DX5SEU_13Subsidiary.fm]
TROUBLESHOOTING
Page 83Thursday, 1 September 2005 13:26
Timer Recording (HDD & DVD Deck)
●
Date and time is not correct.
] Set date and time correctly. (A pg. 77)
●
Timer recording is in progress.
] Timer programming can’t be performed while a timer recording
is in progress. Wait until it finishes.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 77)
●
Date and time set on the unit is not correct.
] Set date and time correctly. (A pg. 77)
●
The channel position does not correspond to that in the
receiving area.
receiving area.
] Set the correct channel position for the receiving broadcast.
●
The unit’s channel positions have been set incorrectly.
] Refer to
B (A pg. 74) and reperform
the procedure.
●
The satellite receiver is not connected properly to this unit.
] Connect the satellite receiver to the [L-2 IN/DECODER]
connector properly. (A pg. 48)
●
Power failure occurred.
] Set date and time correctly. (A pg. 77)
●
16 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer
programming again. (A pg. 47)
●
The PC’s data recorded on a DVD-RAM drive cannot be cleared
on this unit.
on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 9, 78)
Other Problems
For basic connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
q) lights off on the front display panel.
For component video connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
q) lights up on the front display panel.
●
The camcorder’s microphone is too close to the TV.
] Position the camcorder so its microphone is away from the TV.
●
The TV’s volume is too high.
] Turn the TV’s volume down.
●
Those channels have been designated to be skipped.
] If you need the skipped channels, restore them. (A pg. 75)
●
Recording or RetroActive Recording* is in progress.
to resume recording.
* HDD deck only
●
After the manual settings were made, Auto Channel Set was
performed.
performed.
] Perform
] Reset the unit by disconnecting the AC power plug from the AC
outlet and connect again.
Timer programming cannot be made.
Timer programming recording does not start.
S
HOW
V
IEW
Timer Programming cannot be made.
The S
HOW
V
IEW
system does not timer record properly.
Automatic Satellite Programme Recording does not start.
On the front display panel,
A– –:– –B appears.
APROGRAMME FULLB appears on the TV screen during timer
programming.
programming.
The disc space does not increase when recorded titles are
cleared.
cleared.
The image of the TV broadcast appears distorted on the TV
screen.
screen.
Whistling or howling is heard from the TV during camcorder
recording.
recording.
When scanning channels, some of them are skipped over.
The channel cannot be changed.
Channel settings that were made manually seem to have
changed or disappeared.
changed or disappeared.
Malfunction occurs and the unit cannot be power off.
DX5SEU_00.book Page 83 Thursday, September 1, 2005 1:26 PM