JVC ENLPT0736-001B 사용자 설명서

Filename [HM-HDS4EX_07Sub.fm]

Masterpage:Left

Page 98

April 7, 2003 2:57 pm

 

5. “

#” blinks for 10 seconds and the 

Timer mode is disengaged.

● # has been pressed when there are 

no programs in memory.

Check the programmed data and re-
program as necessary, then press 

# 

again.

6. The S

HOW

V

IEW

 system does not 

timer-record properly.

● The recorder’s channel positions 

have been set incorrectly.

Refer to “Guide Program Number 
Set” (

墌

pg. 85) and re-perform the 

procedure.

7. “

䡬

” and “

$” on the front display 

panel won’t stop blinking.

● The end of the tape was reached 

during Instant Timer Recording.

The programme may not have been 
recorded in its entirety. Next time 
make sure you have enough time on 
the tape to record the entire 
programme.

8. “

N”, “

䡬

” and “

$” on the front 

display panel won’t stop blinking.

● The loaded cassette has had its 

record safety tab removed.

Remove the cassette and cover the 
hole with adhesive tape, or insert a 
cassette with the record safety tab 
intact.

● The end of the tape was reached 

during Automatic Satellite 
Programme Recording.

The programme may not have been 
recorded in its entirety. Next time 
make sure you have enough time on 
the tape to record the entire 
programme.

1. Whistling or howling is heard from 

the TV during camcorder 
recording.

● The camcorder’s microphone is too 

close to the TV.

Position the camcorder so its 
microphone is away from the TV.

● The TV’s volume is too high.

Turn the TV’s volume down.

2. When scanning channels, some of 

them are skipped over.

● Those channels have been 

designated to be skipped.

If you need the skipped channels, 
restore them (

墌

pg. 90).

3. The channel cannot be changed.

● Recording is in progress.

Press 

9 to pause the recording, 

change channels, then press 

4 to 

resume recording.

4. Channel settings that were made 

manually seem to have changed or 
disappeared.

● After the manual settings were 

made, Auto Channel Set was 
performed.

Perform manual setting again.

5. No channels are stored in the 

recorder’s memory.

● The TV aerial cable was not 

connected to the recorder when 
Auto Set Up was performed.

Turn off the recorder once and 
connect the TV aerial cable to the 
recorder properly, then turn on the 
recorder again. Then perform Auto 
Set Up again. (

墌

pg. 14)

● The fully-wired 21-pin SCART cable 

was not connected between TV and 
the recorder when Preset 
Download was performed.

Turn off the recorder once and 
connect the fully-wired 21-pin 
SCART cable to the recorder properly, 
then turn on the recorder again. Then 
perform Preset Download again. 
(

墌

pg. 16)

6. The remote control won’t operate 

the TV or satellite receiver.

● The remote control brand setting is 

incorrect.

Re-set the remote control to the 
correct brand. (

墌

pg. 53, 54)

7. A programme that has a title 

“Found 001” is recorded 
unexpectedly on the HDD deck. 

● The power was cut off because of a 

power failure, etc. while the 
recorder was working.

Delete the “Found 001” programme. 
(

墌

pg. 58)

HM-HDS4EX_07Sub.fm  Page 98  Monday, April 7, 2003  2:58 PM