Maxtor NVR-2028 사용자 설명서

Use the “

” and “v” buttons

, and

, to highlight the NET IP. Press the Enter button to

enter the NET IP page

Set the IP, MASK and GATEWAY. Then press the Enter button to proceed. The following

is a sample setting.

IP:

192.168.1.205

MASK: 255.255.255.0

GATEWAY:

192.168.1.254

NOTE: When only one unit of the NVR is connected to a computer or LAN, you can freely

assign an IP address for the NVR. For example, there is a range of NVR IP

addresses from 192.168.1.1 to 192.168.1.255. You can pick one for use from the

range of the IP. It’s not necessary to set MASK and GATEWAY; leave the settings

as default.

When a NVR is connected to a WAN, you must acquire a unique, permanent IP

address and correctly configure the MASK and GATEWAY settings according to

your network architecture. If you have any questions regarding those settings,

please contact a qualified MIS professional or your ISP.

NOTE: When connecting to a network, each connected NVR must be assigned a unique

IP, which must be in the same class type as your network address. IP addresses

are written as four sets of numbers separated by periods; for example,

192.168.1.205 therefore, if the connected network is identified as Class C, for

example, the first three sets of numbers of the NVR IP address must be the same

as the network address. If the connected network is identified as Class B, the

first two sets of numbers of the NVR IP address must be the same as the network

address. If you have any questions regarding these settings, please contact a

qualified MIS professional or your ISP.