Maxtor SLD240 사용자 설명서
45
3. Slide the top cover backward and remove.
4. Set the jumper of your hard disk driver. The way to set the jumper of
the drive varies between manufacturers; please refer to the instructions
on the driver to set the jumpers in the master position.
on the driver to set the jumpers in the master position.
5. Attach the interface connector and the power connector to the drive.
Please note the red lining of the IDE cable must be facing the 4-pin
power connector.
power connector.
6. Place the HDD inside mobile rack. Use four of the provided screws.
7. Place the top cover back to the carrier body by sliding forward to
secure.