Swann SW244-DAO 사용자 설명서

 

 

Use [ Up] and [ Down] button to 

highlight the channel you want to modify 

and press [ SEL] to adjust sensitivity of 

motion detection on each channel. 

When “OFF”, the channel will not 

detect motion or trigger motion recording. 

This number indicates how many 

seconds the motion detection recording 
lasts after the DVR has detected motion. 
 
MOTION ALARM TIME:   

This number indicates how many 

seconds the buzzer/alarm inside the DVR 
will sound after the DVR has detected 
motion.  

CONT: Continuous alarm until press any 
key is pressed when motion detected. 

OFF: No alarm

 

- 11 - 

 
 
 
 
 

MOTION SET:  

 

 

 

 

AREA SET:   

Use [ Up] and [ Down] button to select the channel you want to modify and 

press [ SEL] button to enter the sensitive area of each camera. The picture of the 

selected channel is divided into 144(12*12) blocks, press [REW] to move left, 

press [FWD] to move right, press[ Up] and [ Down] to move the cursor up and 

down, press [ SEL] to set the highlighted block active or disabled.   

When the block is transparent, it’s active or set to detect motion. When the 

block is covered by a shadow, it is not active and motion will NOT be detected. 

Make sure Record Schedule is set to Motion for the times required.