Samsung HL-S5686C 사용자 설명서

English-13

After you have made this connection, set the A/B Switch to the “A” position for normal viewing. Set the A/B switch to the “B” position to view scrambled
channels. (When you set the A/B Switch to “B”, you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)

2. Connect this cable to a two-way splitter.

3. Connect an Antenna cable between an

OUTPUT terminal on the splitter and the 
IN terminal on the cable box.

4. Connect an RF cable between the 

ANT OUT terminal on the cable box and 
the B–IN terminal on the RF(A/B) Switch.

5. Connect another cable between the other

OUT terminal on the splitter and the A–IN 
terminal on the RF (A/B) Switch.

6. Connect the last RF cable between the 

OUT terminal on the RF (A/B) switch and 
the ANT 1 IN (CABLE) terminal on the rear 
of the TV.

If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way
splitter, an RF (A/B) switch, and four lengths of RF cable. (These items are available at most electronics stores.)

1. Find and disconnect the cable that is 

connected to the ANT IN terminal on your 
cable box.

This terminal might be labeled “ANT IN”, 
“VHF IN” or simply, “IN”.

To connect to a cable TV system, follow the instructions below.

1. Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the back of the TV.

Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.

2. Connect the other end of this cable to the ANT 1 IN (CABLE)  terminal on the back of the TV. 

1. Find the cable that is connected to the ANT OUT terminal on your cable box.

This terminal might be labeled “ANT OUT”, “VHF OUT” or simply, “OUT”.

ANT 1 IN
(CABLE)

ANT 1 IN
(CABLE)

BP68-00620A-00Eng  9/14/06  5:27 PM  Page 13