Samsung HL-S5686C 사용자 설명서

English-14

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions 
on pages 12-13). Skip step 1 if you have not yet connected to an antenna or a cable system. 

1. Unplug the cable or 

antenna from the back 
of the TV.

2. Connect the cable or 

antenna to the ANT IN 
terminal on the back 
of the VCR.

3. Connect an RF cable

between the ANT OUT
terminal on the VCR and 
the ANT 2 IN (AIR) or 
ANT 1 IN (CABLE) 
terminal on the TV.

4. Connect a Video cable

between the VIDEO OUT
jack on the VCR and the 
AV IN 1 (or AV IN 2) 
[VIDEO] jack on the TV.

5. Connect Audio cables

between the AUDIO OUT
jacks on the VCR and 
the AV IN 1 (or AV IN 2) 
[R-AUDIO-L] jacks 
on the TV.

If you have a “mono” 
(non-stereo) VCR, use a 
Y-connector (not supplied) 
to hook up to the right 
and left audio input jacks 
of the TV. If your VCR 
is stereo, you must 
connect two cables.

Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.
Also, you can connect to “AV IN 3” on the side panel of TV.

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. 
(This connection delivers a better picture as compared to a standard VHS VCR.)

1. To begin, follow steps 1–3

in the previous section to
connect the antenna or
cable to your VCR and 
your TV.

2. Connect an S-video cable

between the S-VIDEO OUT
jack on the VCR and the
AV IN 1 (or AV IN 2)
[S-VIDEO] jack on the TV.

3. Connect Audio cables

between the AUDIO OUT
jacks on the VCR and the
AV IN 1 (or AV IN 2)
[R-AUDIO-L] jacks
on the TV.

An S-video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)

Each S-VHS VCR has a different back panel configuration.
When connecting an S-VHS VCR, match the color of the connection terminal to the cable.

BP68-00620A-00Eng  9/14/06  5:27 PM  Page 14