Motorola RMM2050 사용자 설명서

English

show ‘Pass’ or ‘Fail’ on the display (a voice 
announcement will be played within 5 seconds).

Once you have completed the cloning process, 

turn the radios OFF and ON to exit the ‘cloning’ 
mode.

Further details on how to clone radios are 
explained in the Instructions Sheet provided 
with the MUC.

When ordering the MUC, refer to P/N# 
PMLN6384_.

•

If cloning fails, refer to “What To Do If Cloning 
Fails” on page 46.

•

Paired Target radios and Source radios must be 
of the same band type in order for the cloning to 
run successfully. 

•

MUC pockets numbers should be read from left to 
right with the Motorola logo facing front.

•

Both CPS and Cloning Cables are made to work 
either with RM Series radios or RDX Series 
radios. Cloning cable supports a mix of RM and 
RDX series radios.

•

CPS cable programs RM series radios. Make 
sure the cable switch is in “Flash” position. To 
program a RDX radio with the CPS cable, make 
sure the cable switch is in “CPS” position and the 
USB converter provided in the CPS cable kit is 
attached to the cable.

•

Cloning cable allows you to clone:

–RM Series radios. Make sure the switch is in 

“Cloning” or “Legacy” position.

–RDX Series radios. Make sure the switch is in 

“Legacy” position with one USB converter on 
each end of the cloning cable.

–RM Series and RDX Series radios. Make sure 

the switch is in “Legacy” position and use a 
USB converter to the RDX Single-Unit Charger. 
The Cloning Cable Kit provides 1 USB 
converter.