Motorola RMM2050 사용자 설명서

English

Unplug any cables (power supply or USB 

cables) from the SUCs.

Plug one side of the cloning cable mini USB 

connector to the first SUC and the other end to 
the second SUC.

During the cloning process, no power is 
being applied to the SUC. The batteries will 
not be charged. Only data communication is 
being established between the two radios.

Turn ON the Target Radio and place it into one 

of the SUCs.

For the Source Radio, power ON the radio with 

the following sequence:

•

Press the PTT button and the SB2 button 
simultaneously while turning the radio ON.

•

Place the Source Radio in its SUC. Press and 
release the SB1 button.

Wait 3 seconds before releasing the buttons 

and you hear a distinctive audible tone saying 
the word “Cloning”.

When the cloning is completed, the Source 

Radio audible voice will announce either 

“successful” (cloning is successful) or “fail” 
(cloning process has failed). If the Source 
Radio is a display model radio, it will either 
show ‘Pass’ or ‘Fail’ on the display (a tone will 
be heard within 5 seconds).

Once the cloning process is completed, turn the 

Radios OFF and ON or, long press the PTT 
button to exit the ‘cloning’ mode.

The radio audible voice will announce “Fail” 
indicating that the cloning process has failed. In 
the event that the cloning fails, perform each of 
the following steps before attempting to start 
cloning process again:

Ensure that the batteries on both radios are fully 

charged.

Check the cloning cable connection on both 

SUCs.

Ensure that the battery is engaged properly on 

the radio.