Shoprider WS 888WS 사용자 설명서

 

4/27/2006 

19

 

Batteries  
Shoprider HD, Shoprider WS 
The Shoprider WS is designed to operate on two 12 volt/36Ah sealed 
lead acid (AGM or gel-cell type) aka SLA maintenance free batteries. 
While the Shoprider HD is designed to operate on two 12 volt/75Ah 
sealed lead acid (AGM or gel-cell type) aka SLA maintenance free 
batteries. The life of the batteries may be affected by temperature, 
terrain, weight of user, driving methods, and care of batteries. It is 
recommended that you charge your batteries after every use. Please 
pay close attention to the light indication on the charger to ensure that 
the batteries are fully charged before taken off of the charger.  
The active user will need to charge the batteries after using 
approximately 30% of battery capacity. As an inactive user, only 
using from once a week to every other day, the recharge point would 
be at 50% of discharge (Refer to Figure 8). For extended battery life, 
it is highly recommended that these guidelines be followed. You 
cannot over charge the batteries. 
*Keeping the batteries charged extends the life of the batteries* 
SLA batteries should be kept fully charged at all times. They must not 
be left in a discharged state if the unit is not being used for some time 
or the batteries will be permanently damaged and will no longer hold 
a charge. The SLA batteries should be checked once a month and 
kept charged as needed. Typically SLA batteries have up to about 
400 charging cycles. 
 

 
 
 
 
 
 
 
 
 
 

Green  Top 

3 Bars 

Full battery charge. 

Red  Bottom 

3 Bars  

Flashing. Danger, you must 
stop and recharge the 
batteries. Failure to do so 
may result in damage of 
batteries. 

Amber  Middle  

4 Bars 

From 30% - 50% 
discharge. Batteries 
will  
need charging. 

 

Figure 14