Shoprider WS 888WS 사용자 설명서

 

4/27/2006 

21

The Self-Help Guide (Table 1) is intended to assist in the location of a 
fault that may occur in a certain part of the Powerchair. 
If after checking the fault from the table below and the fault is still 
showing, do not use the Powerchair.  Turn off the power and consult 
your provider immediately. 

10 Bars flash 

Battery voltage is too high, check the battery connections. 
Call your Shoprider Provider 

9 Bars flash 

Solenoid brake fault. Check drive/freewheel levers. 

8 Bars flash 

Possible controller fault. Check controller connector. Call 
your Shoprider Provider. 

7 Bars flash 

Possible joystick fault. Be sure joystick is at center when 
controller is turned on. Call your Shoprider Provider. 

6 Bars flash 

Battery charger connected. Unplug charger. 

5 Bars flash 

Right-hand motor wiring fault. Check connections. Call 
your Shoprider Provider. 

4 Bars flash 

Right-hand motor disconnected. Check connections. Call 
your Shoprider Provider. 

3 Bars flash 

Left-hand motor wiring fault. Check connections. Call your 
Shoprider Provider. 

2 Bars flash 

Left-hand motor disconnected. Check connections. Call 
your Shoprider Provider. 

1 Bar flash 

Low battery voltage. Charge batteries immediately. Do not 
drive Powerchair until batteries are completely charged! 

Battery/ Charging Troubleshooting 
Shoprider WS & HD– If the charger indicator light has a blinking red 
light after being plugged in and doesn’t charge the batteries the 
batteries may be over discharged or there may be a brake in the 
connection (loose wires or connections) and may require additional 
service or replacement. Contact your provider for assistance. 
If the charger indicator light goes immediately  to green when plugged 
in to charge, the problem is likely a blown fuse popped circuit breaker 
(push reset button) or similar. Contact your provider for assistance.