Stamina Products 55-4286 Manual Do Utilizador
The safety and integrity designed into the AeroPilates® Performer 286 can only be maintained when
the AeroPilates® Performer 286 is regularly examined for damage and wear. Special attention should
be given to the following:
STORAGE
MAINTENANCE
10
1. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
2. Worn or damaged components should be replaced immediately or the AeroPilates® Performer 286
should be removed from service until repair is made.
3. Verify that the
WARNING LABEL(50) is in place and easy to read. Call Stamina Products
immediately at 1-800-375-7520 for a replacement
WARNING LABEL(50) if it is missing or damaged.
4. Verify that the
ROPES(18) are properly installed on the PULLEY SETS(22).
5. Check the condition of the
ROPES(18) and replace if they are frayed or worn.
6. Check the
PLASTIC SNAP HOOKS(19) on the ends of the ROPES(18). Replace the PLASTIC
SNAP HOOKS(19) if they are damaged or deformed.
7. Check the
TENSION CORDS(10). If any of the TENSION CORDS(10) are stretched and loose, re-tie
the knot on the end of the cord. Replace
TENSION CORDS(10) that are frayed or worn.
8. Check the
PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).
9. Check the
HAND STRAPS(20) for damage. Replace damaged parts.
10. Check the
FOAM SLEEVE(6) and FOAM PADS(17) and replace if damaged or worn.
11. Check the
STOP PLATES(27, 29) for looseness or damage and replace any damaged parts.
12. Check the
CUSHION(14) and replace if it is damaged or worn.
13. Check and clean the
ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry
cloth.
14. Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates®
Performer 286.
15. Keep your AeroPilates® Performer 286 clean by wiping it off with an absorbent cloth after use.
1. To store the AeroPilates® Performer 286, simply keep it in a clean dry place.
2. The
FRONT FRAME(1) of the AeroPilates® Performer 286 has built-in wheels for easy moving. To
move, be sure at least one of the tension cords is attached to prevent the
CARRIAGE(7) from sliding,
then lift from the end of the
REAR FRAME(2) and roll.
3. The AeroPilates® Performer 286 folds for storage. To fold, be sure no tension cords are attached
and slide the
CARRIAGE(7) to the end of the REAR FRAME(2). Remove the FOOTBAR(5) and
FOAM PAD ASSEMBLIES(17), then lift the AeroPilates® Performer 286 onto its side with the
LOCKING PIN(26) side up. With the machine hinging in the middle, move the FRONT FRAME(1)
toward the
REAR FRAME(2) until the frame ends meet. Insert the LOCKING PIN(26) into the hole in
the
REAR FRAME(2), and the AeroPilates® Performer 286 is ready to store.