Invacare HF2PCM2KIT Manual Do Utilizador

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE

18

Changing the Carrying Position of the 

Cylinder

NOTE: For this procedure, refer to FIGURE 4.6 on page 19.
The cylinder MUST be kept in the cylinder bag at all times except 

when cleaning. The cylinder MUST be in the bag to ensure the 

cylinder couples with the HomeFill properly.
1. Unhook and remove the cylinder bag and belt from body.
2. Re-attach the buckle.
NOTE: Either end of the belt can be used in this procedure.
3. Unthread one end of the belt from one side of the buckle.
4. Slide the retaining loop off the belt.
5. Pull the end of the belt that has no buckle and retaining 

loop through the two retaining loops on the cylinder bag.

NOTE: The cylinder bag is now removed from the belt.
NOTE: When performing STEP 6, both loops MUST be used on the 

cylinder bag.
6. Perform one of the following:

• For upright use (vertical orientation) of the cylinder 

bag:
i. Stand the cylinder bag upright (vertical 

orientation).

ii. Thread the end of the belt that has no buckle and 

retaining loop through the two loops on the 

cylinder bag. See Detail “A”.

• For sideways use (horizontal orientation) of the 

cylinder bag:
i. Lay the cylinder bag on its side (horizontal 

orientation).