Nikon 140ED Manual Do Utilizador
42
Additional Information
Troubleshooting
Track down the cause of trouble using the following chart.
It may save you a trip to your nearest Nikon service center.
It may save you a trip to your nearest Nikon service center.
Check points and solution
a
The slide cover is not completely open.
→Open the slide cover all the way until it clicks to
→Open the slide cover all the way until it clicks to
turn the camera on.
a
The orange LED blinks.
→The flash is being charged. Once take your finger
→The flash is being charged. Once take your finger
away from the Shutter Release button, lightly
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
a
Letter “ ” lights up on the LCD panel.
→A rewound roll of film is inside. Replace it with
→A rewound roll of film is inside. Replace it with
a new roll.
a
No indicator on the LCD panel.
→The battery is exhausted. Replace it with a new
→The battery is exhausted. Replace it with a new
one.
*
a
All indicators on the LCD panel blink.
→The camera has detected a malfunction. Once
→The camera has detected a malfunction. Once
open the slide cover and close it again, then turn
the power on. If the camera still does not work
properly, remove the battery from the camera and
confirm the indicators turns off, then Install the
battery in place again.
the power on. If the camera still does not work
properly, remove the battery from the camera and
confirm the indicators turns off, then Install the
battery in place again.
*
a
The orange LED blinks.
→The flash is being charged. Once take your finger
→The flash is being charged. Once take your finger
away from the Shutter Release button, lightly
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
a
“
” lights up on the LCD panel.
→The flash does not fire when the subject is bright
enough. To fire the flash, set the camera to the
Anytime Flash mode.
Anytime Flash mode.
a
No indicator or the “
” blinks on the LCD
panel.
→Battery power is low or the battery is exhausted.
→Battery power is low or the battery is exhausted.
Replace the battery with a new one.
*
a
The orange LED blinks quickly.
→Check that the flash unit is not pressed down.
→Check that the flash unit is not pressed down.
Do not touch the flash unit.
The shutter
cannot be
released.
cannot be
released.
The flash does
not fire.
not fire.
Problem
Shutter
Flash
Ref. page
13
11,31
14,15
24,25
24,25
12
11,31
32,34
35
11,31
12
12,13