Panasonic BL-WV10 Manual Do Utilizador

Getting Started

36

It’s taking a lot of time to 
register the cameras.

Network layouts may require a camera re-start, in 
which case registration can take up to 3 minutes.

The image from network 
cameras is not visible.

During Quick Setup, the BL-WV10, after obtaining 
network data from the router, will seek out an IP 
address not currently in use for its own fixed IP. In 
addition, there are fixed IP addresses for cameras on 
which Quick Setup was performed. If the same IP 
address is chosen after Quick Setup, this will cause 
network problems.

•

Either change the IP settings for one of the 
duplicate IP devices, change the network 
settings for the BL-WV10 and the camera(s), 
or re-perform Easy Network Setup after 
resetting the default settings for the BL-WV10 
and re-initializing the camera(s).

A signal from a wireless 
router is being received, 
even though you’re not 
using one.

This will happen when wireless information is 
received from connected devices which support 
Panasonic’s Quick Setup protocol (including the 
BL-WV10 itself).

When 2 BL-WV10 units 
are connected, the IP 
addresses are the same.

When using Quick Setup for more than one 
BL-WV10, the same IP address will be used for each.

•

Change the IP addresses to avoid duplication 
on the network.

The image from cameras 
for which Quick Setup was 
performed is not visible.

When you stand in front of a camera with a PRIVACY 
button (less than 1 m in front of the camera), does the 
PRIVACY button turn green?
If not:

•

Change the camera’s switch from wired to 
wireless.
If it is already set to wireless, re-register the 
camera using Quick Setup.

If so:

•

Check the wireless signal strength. Refer to 
the wireless communication information on 
page 4 and move the camera to a better 
position.

BL-WV10_GS-en.book  Page 36  Wednesday, January 25, 2006  5:18 PM