Avaya 03-300430 Manual Do Utilizador
ANL-16-L (16-Port Analog Line)
Issue 1 June 2005
391
1004
ABRT
The port was seized by a valid call during the test. The test has been
aborted.
aborted.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If
the port is active, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
1005
ABRT
The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018
ABRT
The test has been disabled by administration. The default for the Test field
on the station screen is y. Determine why this field is n on this station. This
may be due to the ringing application Test #48, which can be customer or
terminal disturbing.
on the station screen is y. Determine why this field is n on this station. This
may be due to the ringing application Test #48, which can be customer or
terminal disturbing.
1. To enable the test for the particular analog station being tested, enter
change station extension and set the Test field on the station
to y.
2000
ABRT
Response to the test request was not received within the allowable time
period.
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100
ABRT
System resources required to run this test are not available.
1. Resolve any TONE-PT errors.
2. If there are no TONE-PT errors in the error log, retry the test at
1-minute intervals for a maximum of 5 times.
Any
FAIL
The NPE of the tested port did not conference the tones correctly. This
causes noisy and unreliable connections.
causes noisy and unreliable connections.
1. Enter display port and status station to determine whether
the station is idle. If the station is idle, enter test port for this port.
2. If the test continues to fail, enter busyout port and release port,
and retest.
3. If the test still fails, replace the board.
PASS
The port can correctly conference multiple connections. User-reported
troubles on this port should be investigated by using other port tests and by
examining station, trunk, or external wiring.
Table 114: Test #7 Conference Circuit Test (continued)
Error
Code
Code
Test
Result
Result
Description / Recommendation
2 of 3