Avaya 03-300430 User Manual

1004

ABRT

The port was seized by a valid call during the test. The test has been 
aborted.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If 

the port is active, wait until it is idle.

2. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

The test was aborted due to a configuration problem. This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, the modem pool member or Music On Hold).

1018

ABRT

The test has been disabled by administration. The default for the Test field 
on the station screen is y. Determine why this field is n on this station. This 
may be due to the ringing application Test #48, which can be customer or 
terminal disturbing.

1. To enable the test for the particular analog station being tested, enter 

change station extension and set the Test field on the station 

to y.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run this test are not available.

1. Resolve any TONE-PT errors.

2. If there are no TONE-PT errors in the error log, retry the test at 

1-minute intervals for a maximum of 5 times.

Any

FAIL

The NPE of the tested port did not conference the tones correctly. This 
causes noisy and unreliable connections.

1. Enter display port and status station to determine whether 

the station is idle. If the station is idle, enter test port for this port.

2. If the test continues to fail, enter busyout port and release port, 

and retest.

3. If the test still fails, replace the board.

PASS

The port can correctly conference multiple connections. User-reported 

troubles on this port should be investigated by using other port tests and by 

examining station, trunk, or external wiring.

 2 of 3