Desa VGL18NRA Manual Do Utilizador

www.desatech.com

112882-01D

OPERATING HEATER

Continued

OPTIONAL HAND-HELD

REMOTE OPERATION

Note:

All remote control accessories must be

purchased separately (see Accessories, pages

29). Follow instructions included with the re-

mote control.

NOTICE: You must light the pilot

before using the hand-held re-

mote control unit. See Lighting

Instructions on page 19.

After lighting, let pilot flame burn for about

one minute. Turn control knob to ON posi-

tion. Adjust flame adjustment knob anywhere

between HI and LO. Slide the selector switch

to the REMOTE position (see Figure 30).

Note:

The burner may light if hand-held

remote was on when selector switch was last

turned off. You can now turn the burner on and

off with the hand-held remote control unit.
IMPORTANT:

Do not leave the selector switch

in the REMOTE or ON position when the pilot

is not lit. This will drain the battery.

Figure 30 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

Selector Switch in Remote Position

Control Knob in
On Position

Flame Adjustment
Knob

Figure 31 - On/Off Hand-Held Remote

Control Unit (GHRCB)

Control Button
Turns Burners
On and Off

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote

until burner turns on. Hold the control button

again until burner turns off (see Figure 31).

TO LOCK

press both buttons on hand-held

remote control until light stops ﬂashing. Hand-

held remote control is now locked. If the ﬁre is

on it will be turned off automatically. In the

locked state, the light will not light up when

any button is pressed.
TO UNLOCK

press both buttons together

on hand-held remote control until the light

stops ﬂashing. The hand-held remote is now

unlocked.

THERMOSTAT SERIES (MODEL
GHRCTB)

The hand-held remote can be operated using

either the manual mode (MANU) or thermo-

static mode (AUTO) (see Figure 32). To select

Fahrenheit/Centigrade mode display, carefully

press the ˚C/˚F mode button with the end of a

paper clip or similar blunt object.

Figure 32 - Thermostat Hand-Held

Remote Control Unit (GHRCTB)

Turns Hand-
Held Remote
On or Off and
Allows You
to Choose
the Manual
Setting

Selects Auto
Setting

Increases
Room
Temperature
in AUTO
Mode

Digital
Display
Shows
Temperature
and Settings

Turns
Burners On
or Off

Decreases
Room
Temperature
in AUTO
Mode

Locks System to
Prevent Accidental
Ignition

Manual Mode

1. Press the POWER and LOCK buttons

together to turn on the hand-held remote

control.

2. Press the MANU button to turn on the

ﬁreplace.

3. Press the POWER and LOCK buttons

together to turn off the ﬁreplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons

together to turn on the hand-held remote

control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by press-

ing the TEMP + or - buttons.