FMI CCL3924PTA/NTA Manual Do Utilizador

www.fmiproducts.com

124971-01C

8

INSTALLATION

WARNING: Before installing

in a solid fuel burning fireplace,

the chimney flue and firebox

must be cleaned of soot, creo-

sote, ashes and loose paint by

a qualified chimney cleaner.

Creosote will ignite if highly

heated. A dirty chimney flue may

create and distribute soot within

house. Inspect chimney flue and

firebox for damage. If damaged,

repair flue and firebox before

operating heater.

WARNING: Seal any fresh

air vents or ash clean-out doors

located on floor or wall of fire-

place. If not, drafting may cause

pilot outage or sooting. Use a

heat-resistant sealant. Do not

seal chimney flue damper.

Figure 3 - Ventilation Air from Outdoors

Outlet

Air

Ventilated

Attic

Outlet

Air

Inlet

Air

Inlet Air

Ventilated

Crawl Space

To

Crawl

Space

To Attic

Ventilation Air From Outdoors

Provide extra fresh air by using ventilation

grills or ducts. You must provide two perma-

nent openings: one within 12" of the ceiling

and one within 12" of the floor. Connect these

items directly to the outdoors or spaces open

to the outdoors. These spaces include attics

and crawl spaces. Follow the National Fuel

Gas Code, ANSI Z223.1/NFPA 54, SAir for

Combustion and Ventilation for required size

of ventilation grills or ducts.
IMPORTANT: Do not provide openings for

inlet or outlet air into attic if attic has a thermo-

AIR FOR COMBUSTION AND VENTILATION

Continued

stat-controlled power vent. Heated air entering

the attic will activate the power vent.

NOTICE: This heater is intended

for use as supplemental heat.

Use this heater along with your

primary heating system. Do not

install this heater as your pri-

mary heat source. If you have a

central heating system, you may

run system’s circulating blower

while using log heater. This will

help circulate the heat from your

log heater throughout the house.

In the event of a power outage,

you can use this heater as your

primary heat source.

WARNING: A qualified ser-

vice person must install heater.

Follow all local codes.

NOTICE: State or local codes

may only allow operation of this

appliance in a vented configura-

tion. Check your state or local

codes.