Hunter Fan 45003-01 Manual Do Utilizador

45003-01  •  07/02/2009  •  Hunter Fan Company

2-1.  Drill two pilot holes into the wood support structure through the 

outermost holes in the outlet box. The pilot holes should be 9/64” 

in diameter.

    Note: Your fan comes with four pre-installed neoprene noise 

isolators. 

2-2.  Thread the lead wires from the outlet box down through the hole 

in the middle of the hanger bracket.

2-3.  Align the slotted holes in the hanger bracket with the pilot holes 

you drilled in the wood support structure. For proper alignment 

use slotted holes directly across from each other. If you are 

installing the fan on an ANGLED ceiling, be sure to orient the 

hanger bracket as shown in Illustration 2-3 (left or right view).

    Note: The isolators should be flush against the ceiling.
2-4.  Place a flat washer on each of the two 3” screws and pass the 

screws through the slotted holes in the hanger bracket into the 

pilot holes you drilled. 

    Tighten the screws into the 9/64” pilot holes; do not use lubricants 

on the screws. Do not over tighten.

Flat Washer

3” Screw

Hanger 

Bracket

Isolator

Ceiling Peak

Ceiling Peak

Large

Opening

Large

Opening