Hunter Fan 27188 Manual Do Utilizador

41797-01  •  07/06/10  •  Hunter Fan Company

1. This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

2. This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference 

in a residential installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or 

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from the one the 

receiver is connected to.

• Consult the dealer or an experienced radio/TV technician for help.

3. For use only with electrically reversible ceiling fans rated at 1.0 amp or less, 

and fan incandescent light kits rated at 300 watts or less. 

4. Not for use with shaded-pole motors, Hunter 42” Low Profile fans, and 

Hunter Baseball fans. Not recommended for use with the Hunter Original®. 

For Hunter Original® series fans, use Hunter control model numbers 27187, 

22691, or 27189.

5. Medium and Low fan speeds are determined by the control and thus may vary 

from the factory settings due to normal motor variations.

6. For use with Hunter Hanging Systems (excludes Hunter Original) on flat 

ceilings or angled ceilings with a pitch up to 34°.

7. Not for use in applications where the fan does not have a wall switch.