Hunter Fan 27188 Manual Do Utilizador

41797-01  •  07/06/10  •  Hunter Fan Company

4. Install the ceiling fan according to its instructions, up to the point of making 

the electrical connections. Connect receiver to ceiling fan according to the 

mounting types shown on the next page. Determine your ceiling fan mounting 

type from the images on Pages 5-6. Most installations will be one of these 

five types.

5. If the fan is already installed, turn the power OFF at the main electrical panel. 

Reverse the installation procedure according to the fan instructions, to the 

point of disconnecting the fan wiring. Connect the receiver to the ceiling fan 

according to the mounting type as shown on Pages 5-6. 

NOTE: Some fans may have considerable excess lead wire. For easier 

canopy installation, cut the excess wire leaving a minimum of 6 inches  

remaining. Restrip the fan lead wires 1/2 inch. Place remaining excess wire into 

the ceiling electrical box as needed. 

Canopy Hanger (Figure 4): Place receiver in canopy. Connect wiring as 

shown in Figure 4. Extend antenna through one of the ceiling plate openings 

(approximately 3–6˝).

Low Profile Style I (Figure 5): Secure receiver to the fan plate 

above the motor with UL listed cable ties (not included). Connect wiring as 

shown in Figure 5. Extend antenna through one of the ceiling plate openings 

(approximately 3–6˝).

Low Profile Style II (Figure 6): Secure receiver to the ceiling mounting 

bracket with UL listed cable ties (not included). Connect wiring as shown in 

Figure 6. Extend antenna above the ceiling mounting bracket (approximately 

3–6˝).

Fans (Figs.5-6): Insert cable tie through 

openings as shown. DO NOT insert the cable 

tie through the inside of the receiver. The 

cable tie can be placed across the length or 

width of the receiver to best match your fan 

installation type.

Antenna