Broan QTXE150FLT Manual Do Utilizador

Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.

Snap damper /
duct connector
onto housing.
Make sure con-
nector is flush with
top of housing and
damper flap falls
closed.

Connect 6-inch
round ductwork
to damper / duct
connector. Run
ductwork to a
roof cap or wall
cap. Tape all
ductwork connections to make them secure and air tight.

Sliding hanger bars are provided to allow for accurate posi-

tioning of housing anywhere between framing. They can be

used on all types of framing (

I-joist, standard joist, and truss

construction) and span up to 24”.

Attach  the  MOUNTING  CHANNELS  to  the  housing  using

the SCREWS supplied. Make sure TABS face “up” as shown.

Use the set of channel mounting holes (marked “STD”) to

mount the housing flush with the bottom of the drywall. Use

the other set of holes (not marked) to mount the housing

flush with the top of the drywall.

HANGER

BAR (4)

SCREWS (4)

TAB

Extend HANGER BARS to the width of the framing.

Hold  ventilator  in  place  with  the  hanger  bar  tabs  wrapping

around the BOTTOM EDGE OF THE FRAMING.

NAIL ventilator to framing or fasten with screws (not provided)

through HOLES near nails.

*

To ensure a noise-free mount: Secure hanger bars together

with  SCREWS  or  use  a  pliers  to  crimp  mounting  channels

tightly around hanger bars.

HOLE FOR OPTIONAL

SCREW MOUNTING (4)

MOUNTING

CHANNEL (2)

NAIL (4)

BOTTOM EDGE

OF FRAMING

*

SCREW (2)