Louisville Tin and Stove W505F Manual Do Utilizador

CAUTION:  Label all wires prior to disconnection when

servicing controls.  Wiring errors can cause improper
and dangerous operation.  Verify proper operation
after servicing.

WARNING:  Failure to locate the thermostat properly

or to wire the furnace correctly may result in continuous

operation, control damage or failure to operate.  This can

cause property damage, personal injury, or loss of life.

Follow the instructions included with the thermostat.  Locate
the thermostat approximately five (5) feet above the floor
and four feet (4’) from appliance.  Always mount the
thermostat on an inside wall where it won’t be affected by
heat or cold sources such as direct sunlight, televisions,
fireplaces, hidden hot or cold water pipes, drafts, etc.  The
thermostat must never be installed in an adjoining room where
a door can be closed between the thermostat and wall
furnace.  This wall furnace is equipped with a self generating
control system.  Never connect to a 24 volt transformer or
to the household electrical system.  Do not use more
thermostat wire than is included with the wall furnace.  Do
not run thermostat wire in same stud space with vent.
Conceal wire inside wall or secure to wall with insulated
staples that are included .

YOUR FURNACE IS SHIPPED WITH  A WALL
THERMOSTAT (Figure 8).  YOU MAY CONVERT
CONTROL TO BUILT-IN BULB CONTROL WITH
THE OPTIONAL BBSK KIT.  SEE PAGE 13, 14 and 15
FOR INSTALLATION INSTRUCTIONS.

Page 10

W255F W256F
W355F W356F
W505F W506F

FIGURE 8

Thermostat

Manual
Reset
Blocked
Flue Switch

Wire
Nut

     Pilot
Generator

Gas Valve