Wayne-Dalton AND 9600 Manual Do Utilizador

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.Wayne-Dalton.com

#1 END 
HINGE

#2 END  
HINGE

#3 END 
HINGE

#4 END 
HINGE

asTRaGal

BOTTOM 
BRaCkET

BOT.

lOCk

1 3/8”

1 19/32”

INT.

INT.

(usED ONly 

ON fIVE 

sECTIONs)

1 1/8”

7/8”

TOP sECTION

INTERMEDIaTE sECTION

lOCk sECTION

BOTTOM sECTION

BOTTOM BRaCkET 

WaRNING laBEls

asTRaGal

#3

#2

#1

WaRNING laBEl

WaRNING laBEl

NOTE: This provides an alternative 

method for identifying your door 

sections/stacking position.

Hinges are always pre-attached at 

the top of each section (except top 

section) and the hinges are stamped 

for identification, #1, #2, #3, and #4 (#4 

only on five section doors). see view 

below. The stamp identifies the stacking 

sequence of the section. The sequence 

is always determined by #1 being the 

bottom section to #3 or #4 being the 

highest intermediate section. see views 

to the right. If the stamp on the end 

hinge is illegible, refer to the section 

side view illustration to the right.

The section side view illustration shows 

the end hinge profile of all the sections, 

and can also be used in conjunction 

with identifying each sections.

The 

bOTTOM SECTION can be 

identified by #1 end hinges, the factory 

attached bottom astragal, and by the 

bottom bracket warning labels on each 

end stile.

The 

lOCk SECTION can be identified 

by #2 end hinge. 

The 

INTERMEDIATE SECTION can be 

identified by #3 end hinges. The section 

will have a warning label attached to 

either the right or left hand end stile.

NOTE: #4 End hinges are used on the 

fourth section of five section doors.

The 

TOP SECTION can be identified 

with no pre-installed end or center 

hinges and u-bar attached to the top 

section.