Hampton Direct H15-LP1 Manual Do Utilizador

30

Hampton

®

 H15-1 Direct Vent Freestanding Gas Stove

19)  Remove the control panel by unscrewing 

the 2 screws.

21)  Plug up the Piezo hole with the plastic 

bushing.

22)  Attach the DC sparker generator 

connector to the valve with a screw.

23)  Remove the stove’s rear panel by unscrew-

ing the two screws.

24)  Attach the ground wire to the grounding 

stud.

20)  First, remove the Piezo Ignition Wire 

from the Piezo Ignitor. Then remove the 
Piezo Ignitor from the control panel.

12)  Pull off the 

pilot cap to 
expose the 
pilot orifi ce.

13)  Unscrew the pilot orifi ce with the allen 

key and replace with the LP pilot orifi ce 
in the kit.

14)  Remove burner orifi ce with a 1/2" 

wrench and discard. Use another 
wrench to hold on to the elbow behind 
the orifi ce.

15)  Reinstall new burner orifi ce LP stamped 

#55 and tighten.

16)  Reverse steps 3) to 2).

17)  Attach the label "This unit has been 

converted to LPG" near or on top of the 
serial # decal.

18)  Replace yellow "Natural Gas" label with 

red "LPG" label.

11) Reassemble the black protection cap 

(Fig. 6).

are appropriate for the gas type.