Hampton Direct H15-LP1 Manual Do Utilizador
32
Hampton
®
H15-1 Direct Vent Freestanding Gas Stove
A)
D)
B)
C)
LOG SET INSTALLATION
1) Shut off the gas supply.
2) Lift
off
Cast
Top.
Read the instructions below carefully and refer to the diagrams.
If the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
If the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a) Rear
Log
b) Left
Side
Front
Log
c) Right
Side
Front
Log
d) Center
Front
Log
e) Embers
902-156
f) Platinum
Embers
946-669
(supplied with packaged manual)
Left Front Log
Right Front Log
A)
B)
4) Remove
Glass
Door.
5) Carefully remove the logs from the unit and unwrap them. The logs
are fragile, handle with care - do not force into position.
C)
3) Remove Cast Front by removing the 2 screws using a 7/16" wrench.
Pull front out and then up as shown below.
Inside
view
6) Place the rear log on the 2 rear log locating pins on the rear of the
burner with the fl at side to the back.
7) Place the 2 front logs on the front log locating pins. Ensure the back
of both logs rest against the tabs.
INSTALLATION