Hampton Direct H15-LP1 Manual Do Utilizador

34

Hampton

®

 H15-1 Direct Vent Freestanding Gas Stove

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.

Use the Hampton

®

 Remote Control Kit approved 

for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

A wall thermostat may be installed if desired. 
Connect the wires as per the wiring diagrams. 
Note that the wires are  connected to the "TH" 
on the gas valve. Use table below to determine 
the maximum wire length:

Hampton

®

 offers an optional programmable 

thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

50 Ft.
32 Ft.
20 Ft.
12 Ft.

9 Ft.

Wire Size                       Max. Length

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location, use Thermostat Wire Table.

2)  Connect the wires as per the wiring diagram 

below.

Before leaving this unit with the customer, the 
installer must ensure that the appliance is fi ring 
correctly. This includes:

1)  Clocking the appliance to ensure the cor-

rect fi ring rate (rate noted on label) at 15 
minutes.

2)  If required, adjusting the primary air to ensure 

that the fl ame does not carbon. First allow 
the unit to burn for 15 min. to stabilize.

3) Check 

for 

proper 

draft.