Desa PCBM-325 Manual Do Utilizador
InstallatIon InstructIons for
PcBM-325 conversIon kIt
convertIng froM natural gas to ProPane/lP gas
for use When converting Model (v)P325(B)
vented Decorative fireplace
This conversion kit must be
installed by a qualified service
person.
Read these instructions completely before
installing this conversion kit.
Before proceeding, make sure the gas con-
trol valve is in the OFF position, all electrical
power to the appliance is OFF, and the fire-
place is cool to the touch.
installing this conversion kit.
Before proceeding, make sure the gas con-
trol valve is in the OFF position, all electrical
power to the appliance is OFF, and the fire-
place is cool to the touch.
CAUTION: The gas supply
shall be shut off prior to dis-
connecting the electrical power
before proceeding with the
conversion.
Parts included with this kit:
Part No. Description
Qty.
108805-01 Instruction Sheet
1
108085-02 Pilot Orifice LP
1
901065-09 Main Burner Orifice LP
1
901066-02 Air-Mixer Brass LP
1
106380-01 Gas Valve Regulator
1
108808-02 Conversion Label, English
1
108809-02 Conversion Label, French
1
106080-01 Conversion Information Label 1
Tools Required:
• 7/8" Open End Wrench or Adjustable
Tools Required:
• 7/8" Open End Wrench or Adjustable
Wrench
• 3/4" Open End Wrench or Adjustable
Wrench
• 3/8" Deep Socket Drive
• Torx T20 or Slotted Screwdriver
• 5/32" Allen Wrench
• #2 Short Phillips Screwdriver
• Thread Sealant (Resistant to Propane/LP )
• Torx T20 or Slotted Screwdriver
• 5/32" Allen Wrench
• #2 Short Phillips Screwdriver
• Thread Sealant (Resistant to Propane/LP )
ACCessINg FIrePlACe
You may access burner system through open-
ing in front of unit.
1. Remove front glass panels (if installed).
ing in front of unit.
1. Remove front glass panels (if installed).
This will keep them from being damaged.
To remove, partially open doors. Press
up on upper spring clip of one door panel
with a screwdriver until outer top pivot pin
is free of clip (see Figure 1). Repeat with
second door panel. Place glass panels
safely out of your work area.
To remove, partially open doors. Press
up on upper spring clip of one door panel
with a screwdriver until outer top pivot pin
is free of clip (see Figure 1). Repeat with
second door panel. Place glass panels
safely out of your work area.
2. Slide open screens and tuck inside outer
pockets on firebox.
3. Remove front refractory access panel by
lifting up and angling out of firebox open-
ing (see Figure 2, page 2).
ing (see Figure 2, page 2).
Figure 1 - Removing Glass Doors
Spring
Clip
Clip
Depress Spring Clip to
Release Pivot Pin
Release Pivot Pin
Remove Bottom Pin From
Pivot Plate While Sliding Door
Out of the Upper Track
Pivot Plate While Sliding Door
Out of the Upper Track
Pivot
Plate
Plate
Fold Bi-Fold
Door After
Releasing
Spring Clip
and Slide
Door Out
of Upper
Track
Door After
Releasing
Spring Clip
and Slide
Door Out
of Upper
Track
www.desatech.com