Desa PCBM-325 Manual Do Utilizador
www.desatech.com
108805-01C
3
gAs CONTrOl vAlve
CONversION
CONversION
Convert gas control valve by changing out the
valve regulator portion of gas valve.
1. Using a TORX T20 or slotted screwdriver,
valve regulator portion of gas valve.
1. Using a TORX T20 or slotted screwdriver,
remove and discard three mounting
screws, pressure regulator tower, and
diaphragm/spring components (see Fig-
ure 5).
screws, pressure regulator tower, and
diaphragm/spring components (see Fig-
ure 5).
2. Insure rubber gasket is properly posi-
tioned on new pressure regulator as-
sembly. Install new pressure regulator
assembly to valve using new mounting
screws supplied with kit. Tighten screws
securely (approximately 25 in-lbs.) See
Figure 6.
sembly. Install new pressure regulator
assembly to valve using new mounting
screws supplied with kit. Tighten screws
securely (approximately 25 in-lbs.) See
Figure 6.
3. Install the identification label enclosed with
gas valve regulator to valve body where it
can easily be seen (see Figure 6).
can easily be seen (see Figure 6).
Figure 5 - Removing Mounting Screws,
Pressure Regulator Tower, and
Diaphragm/Spring Components
O
F
F P
IL
O
T
O
N
Mounting
Screws
Screws
Pressure
Regulator
Tower
Regulator
Tower
Diaphragm/
Spring
Components
Spring
Components
Figure 6 - Installing Pressure Regulator
Assembly
O
FF
PI
L
OT
ON
Mounting Screws
Rubber Gasket
Identification
Label
Label
CONversION lABelINg AND
PlACeMeNT
PlACeMeNT
1. Apply the English and French conversion
labels over the top of existing certification
labels (see Figure 7). Existing certification
labels are located on the lighting instruc-
tion plate inside the gas valve compart-
ment area. With permanent ink, print the
previous model number on the label in the
space provided (see Figure 8, page 4).
labels (see Figure 7). Existing certification
labels are located on the lighting instruc-
tion plate inside the gas valve compart-
ment area. With permanent ink, print the
previous model number on the label in the
space provided (see Figure 8, page 4).
Figure 7 - Applying English and French
Conversion Labels Over Existing
Certification Labels on Lighting
Instruction Plate
English This
Side
Side
French This
Side
Side
Lighting
Instruction
Plate
Instruction
Plate