Honeywell MS-9600LSE Manual Do Utilizador

142

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

Programming

Pressing 2 while viewing the Program Check screen will display a screen similar to the following: 

The Zone No Input screen allows the programmer to view the zones which have not been pro-
grammed to at least one input device (not including general alarm Zone 00). The example in the 
preceding screen indicates that Zones 05, 07, 09, 10, and 11 have been programmed to an address-
able module (control module in this example) with an address of 001 on loop 1 but have not been 
programmed to any input devices.  Use the up and down arrow keys to view all the zones without 
input assignments.

Pressing 3 while viewing Program Check screen will cause a screen similar to the following to be 
displayed:

The Zone No Output feature allows the programmer to view the zones which have not been pro-
grammed to at least one output device (not including general alarm Zone 00). The example in the 
preceding screen indicates that Zones 05, 07, 09, 10, and 11 have been programmed to an address-
able detector with an address of 001 on loop 1 but have not been programmed to any output 
devices.  Use the up and down arrow keys to view all the zones without output assignments.

To perform a walktest, press 1 while viewing Maintenance Screen #2.  The following screen will be 
displayed:

The operator can press 1 to perform a silent walktest or 2 to perform an audible walktest.  The dis-
play will read UNIT IN WALKTEST.  To end the Walktest, press the Esc (Escape) key.

Pressing 3 after the walktest has been completed, will allow the operator to view the results of the 
walktest.

   ZONES NO INPUT

05 07 09 10 11 1M001

   ZONES NO OUTPUT

05 07 09 10 11 1D001

    PROGRAMMING

1=WALKTEST

2=SYSTEM

3=ZONE SETUP

Maintenance Screen #2

     WALKTEST

1=SILENT

2=AUDIBLE

3=VIEW RESULT