ONKYO HT-R340 Manual Do Utilizador

 

59

 

• The subwoofer outputs no sound while only speaker 

set B is on. Turn on speaker set A.

• When you play source material that contains no infor-

mation in the LFE channel, the subwoofer produces 
no sound.

• Make sure the speakers are configured correctly 

(page 55).

• If the multichannel DVD input is selected and speaker 

set B is on, speaker set A is reduced to 2-channel play-
back, so the subwoofer outputs no sound.

• On the AV receiver, the subwoofer setting in the 

speaker configuration is set to No. Set the subwoofer 
setting to Yes.

 

• Check the digital audio output setting on the con-

nected device. On some games consoles, such as those 
that can play DVDs, the default setting is off.

• With some DVD-Video discs, you need to select an 

audio output format from a menu.

 

• When speaker B is turned on, speaker set A is reduced 

to 2.1-channel playback.

 

• When the subwoofer volume level is set to a positive 

(+) value, the maximum master volume level is 
reduced proportionally.

 

• Using cable ties to bundle audio cables with power 

cords, speaker cables, and so on may degrade the 
audio performance, so don’t do it.

• An audio cable may be picking up interference. Try 

repositioning your cables.

 

• Make sure the source material is Dolby Digital 

 

• Check the DVD analog multichannel input connec-

• To select the DVD analog multichannel input, press 

the [MULTI CH] input selector button (page 40).

• Check the audio output settings on your DVD player.

 

• When DTS program material ends and the DTS bit-

stream stops, the AV receiver remains in DTS listening 
mode and the DTS indicator remains on. This is to pre-
vent noise when you use the pause, fast forward, or fast 
reverse function on your player. If you switch your 
player from DTS to PCM, because the AV receiver 
does not switch formats immediately, you may not hear 

any sound, in which case you should stop your player 
for about three seconds, and then resume playback.

• With some CD players, you won’t be able to playback 

DTS material properly even though your player is con-
nected to a digital input on the AV receiver. This is 
usually because the DTS bitstream has been processed 
(e.g., output level, sampling rate, or frequency 
response changed) and the AV receiver doesn’t recog-
nize it as a genuine DTS signal. In such cases, you 
may hear noise.

• When playing DTS program material, using the pause, 

fast forward, or fast reverse function on your player 
may produce a short audible noise. This is not a mal-
function.

 

• Make sure that all video connecting plugs are pushed 

in all the way (page 26).

• Make sure that each video component is properly con-

nected.

• The AV receiver does not convert between formats, so 

if a video source component is connected to a compo-
nent video input, your TV must be connected to the 
component video output (page 27).

• On your TV, make sure that the video input to which 

the AV receiver is connected is selected.

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 41).
• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

HT-S3100_3105_En.book Page 59 Friday, February 1, 2008 9:14 AM