ONKYO HT-S5300 Manual Do Utilizador

En

You can enter a preset name for each individual input 
selector for easy identification. When entered, the preset 
name will appear on the display.

■

`

- - -, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo, 
CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD, 
TAPE, iPod:

To reset to the default, select “- - -”.

• Can not set the input selector by the same name.
• This menu cannot be used for the TUNER input selector.

If the impedance of any speaker is 4 ohms or more but less 
than 6, set the minimum speaker impedance to 4 ohms.

• Before you change these settings, turn down the volume.

■

`

4ohms:

Select if the impedance of any speaker is 4 ohms or 
more but less than 6.

`

6ohms:

Select if the impedances of all speakers are between 
6 and 16 ohms.

• (North American models) Do not support speakers with an 

impedance of less than 6 ohms.

■

`

Front High: 

Front high speakers can be used.

`

Zone2: 

Zone2 speakers can be used.

Select “Zone2” if you’ve connected your Zone 2 speakers 
to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-
nals (

■

`

Front High: 

Front high speakers can be used.

`

SurrBack: 

Surround back speakers can be used.

Select “Front High” if you’ve connected your Zone 2 
speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/
R terminals, and the front high speakers to SURR BACK 
OR FRONT HIGH SPEAKERS L/R terminals.

• If the “Front High/Zone2” setting is set to “Front High”, this 

setting is set to “SurrBack”.

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differenti-
ate the AV receiver from the other components, you can 
change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

For FM/AM tuning to work properly, you must specify the 
FM/AM frequency step used in your area. Note that when 
this setting is changed, all radio presets will be deleted.

■

`

Select if 200 k/10 kHz steps are used in your area.

`

Select if 50 k/9 kHz steps are used in your area.

■

`

Select if 10 kHz steps are used in your area.

`

Select if 9 kHz steps are used in your area.

Preparation
Press the input selector buttons to select an input source.

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.