ONKYO HT-S5300 Manual Do Utilizador

En

• The 

“Power Control”

 setting can be set only when the above 

“

”

 setting is set to “On”.

• HDMI power control only works with 

p-compatible 

components that support it and may not work properly with 
some components due to their settings or compatibility.

• When set to “On”, power consumption will increase.
• When set to “On”, regardless of whether the AV receiver is On 

or in Standby, both audio and video stream from an HDMI input 
will be output to the TV or other components via HDMI connec-
tion (HDMI pass through function). When the HDMI pass 
through function activates in standby mode, HDMI THRU indi-
cator will light.

• The power consumption during standby mode will increase dur-

ing the HDMI pass through function; however in the following 
cases, the power consumption can be saved:
1. The TV is in standby mode.
2. You are watching a TV program.

• Refer to the connected component’s instruction manual for 

details.

■

`

Off: 

TV Control disabled.

`

On:

TV Control enabled.

Set to “On” when you want to control the AV receiver 
from an 

p-compatible TV that is connected to 

HDMI.

• Do not assign the component connected with the HDMI input to 

the TV/CD selector when you set “TV Control” setting to “On”. 
Otherwise, appropriate CEC (Consumer Electronics Control) 
operation is not guaranteed.

• Set  to 

“

”

 when the TV is not compatible or when it is unclear 

whether the TV is compatible or not.

• The 

“TV Control”

 setting can be set only when the above 

“

”

 and 

“Power Control”

 settings are both set 

to “On”.

• Refer to the connected component’s instruction manual for 

details.

You can change various audio settings by pressing 
AUDIO.

These settings are disabled when:

• a pair of headphones is connected, or
• the  “Audio TV OUT” setting is set to “On” (

40) and an input 

selector other than HDMI is selected.

You can adjust the bass and treble for the front speakers, 
except when the Direct listening mode is selected.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut low-frequency sounds output 
by the front speakers.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut high-frequency sounds output 
by the front speakers.

• To bypass the bass and treble tone circuits, select the Direct lis-

tening mode.

• This procedure can also be performed on the AV receiver by 

using its TONE, –, and + buttons (

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to Standby. To save the setting you made 
here, go to “Level Cal (Level Calibration)” (

setting the AV receiver to Standby.

■

`

–15 dB to 0 dB to +12 dB in 1 dB steps

■

`

–12 dB to 0 dB to +12 dB in 1 dB steps

• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “Sp Config 

35) cannot be adjusted.

After changing the settings of the “HDMI Control”, 
“Audio Return Ch”, “Power Control”, or “TV Con-
trol”

, turn off the power to all connected pieces of 

equipment and then turn them on again. Refer to the 
User’s Manuals for all connected pieces of equipment.

q/w to select an item, and e/r to change the 

setting.
Repeat this step for the other settings.