Lochinvar 000 BTU/HR Manual Do Utilizador
25
3.
Set the thermostat to the lowest setting (OFF).
4.
Turn off all electrical power to the appliance.
5.
Turn the gas control knob on the gas valve
clockwise to the “OFF” position.
clockwise to the “OFF” position.
FIG. 33 F1 Gas Valve 90,000 - 270,000 Btu/hr Models
6.
Wait five (5) minutes to clear out any gas, then
smell for gas, including near the floor. If you smell
gas, STOP! Follow the steps in the“What To Do If
You Smell Gas” section in the safety information
on page 24. If you do not smell gas go on to the
next step.
smell for gas, including near the floor. If you smell
gas, STOP! Follow the steps in the“What To Do If
You Smell Gas” section in the safety information
on page 24. If you do not smell gas go on to the
next step.
7.
Remove the lower panel door to gain access to the
pilot.
pilot.
8.
Find the pilot - Follow the metal tube from the gas
valve to the pilot. The pilot is located on the right
side of the burner approximately centered in the
burner tray.
valve to the pilot. The pilot is located on the right
side of the burner approximately centered in the
burner tray.
FIG. 34 Pilot Location
9.
Turn the control knob on the gas valve
coun ter clock wise to the “PILOT” position.
coun ter clock wise to the “PILOT” position.
FIG. 35 Lighting Wand
10. Use the loop end of the wire lighting wand,
shipped with the instruction pack age, to hold the
match and reach the pi
match and reach the pi
lot. An access slot is
provided in the lower front jacket panel, beside the
burner, to insert the lighting wand and match to the
pilot. Lift the pilot cover (FIG. 35) to access the
pilot. Push down and hold in the red button on the
gas valve. This should start gas flow to the pilot.
Con tin ue to hold the red button in for about one (1)
minute after the pilot is lit. Release the button and
it will pop back up. The pilot should remain lit. If
the pilot goes out, repeat steps 5 through 10.
burner, to insert the lighting wand and match to the
pilot. Lift the pilot cover (FIG. 35) to access the
pilot. Push down and hold in the red button on the
gas valve. This should start gas flow to the pilot.
Con tin ue to hold the red button in for about one (1)
minute after the pilot is lit. Release the button and
it will pop back up. The pilot should remain lit. If
the pilot goes out, repeat steps 5 through 10.
If the red button does not pop up when re leased,
stop and immediately call your gas supplier.
stop and immediately call your gas supplier.
If the pilot will not stay lit after sev er al tries, turn
the gas control to “OFF” and call your
service technician or gas supplier.
the gas control to “OFF” and call your
service technician or gas supplier.
11. Turn the gas control knob on the gas valve
counterclockwise to the “ON” position.
12. Turn on all electric power to the appliance.
13. Re-install the lower panel door.
14. Set the thermostat to the desired setting.
15. Re-install the control panel door.
The information package shipped with the
appliance contains a wire lighting wand. The loop
end of the wand will hold a match. The wand
extends your reach to the pilot and makes lighting
the pilot easier.
appliance contains a wire lighting wand. The loop
end of the wand will hold a match. The wand
extends your reach to the pilot and makes lighting
the pilot easier.
NOTE: