ONKYO MD-105TX Manual Do Utilizador

28

The MD recorder is now in recording
standby mode.

If “D. In Unlock” appears
The digital input source is not connected
properly. Check the connection for the
digital input source.

Refer to Step 7-1 and 7-2 on page 25.

To stop recording temporarily
Press the 

 button (or the   button on the

remote control). To resume recording, press the

 button again (or press the 

  button on

the remote control).

To stop recording
Press the   button.

To eject the MD
Press the   button and then the   EJECT button.
Even with the Level Sync function turned off,
recording digital data from a CD to an MD
automatically numbers the tracks.

• For track numbers to be marked

automatically, the signature code included in
the digital signal at the beginning and end of
each track is necessary. Some equipment and
broadcasts do not include this signal, and in
such a case track numbers will not be marked
automatically.

In this case, the tracks are not numbered
automatically. Use the Level Sync function
described on the next page.

If the TOC indicator is lit steadily or flashing...
The track number and other information is
written in the MD’s TOC (Table of Contents) area
when the MD recorder ejects the disc, enters
stand-by mode, or stops recording.
Do not disconnect the power cable or move the
unit under the following circumstances. Otherwise,
the information will not be written correctly.
• The TOC indicator is lit.

The information to be written into the MD’s
TOC area is currently stored in the recorder’s
memory.

The recorder is now writing the information in
the MD’s TOC area.

The TOC indicator appears as recording
starts.
The MD recorder stops recording
automatically when the remaining space
on the MD is insufficient to record the
next track.

MINIDISC RECORDER 

STANDBY

CD

INPUT

DUBBING

PUSH TO ENTER

(

)

AMCS

DISPLAY

EDIT / NO

YES

REC

STANDBY / ON

MD-

105TX

REC MODE

REC

EDIT/NO

AMCS