ONKYO MD-105TX Manual Do Utilizador

26

To manually record a track number
While recording, press the   REC button when
you wish to mark a track number.
If you wish to mark two or more track numbers
sequentially, provide a sufficient interval
between each press of the   REC button. Too
short an interval (about 4 seconds or less) may
lead to a failure in marking track numbers.

To stop recording temporarily...
Press the 

 button (or the   button on the

remote controller). To resume recording, press
the 

 button  (or press the 

 button on the

remote controller).

To stop recording...
Press the   STOP button.

To eject the MD...
Press the   STOP button, then the   EJECT
button.

If the TOC indicator is lit steadily or flashing...
The track number and other information is
written in the MD’s TOC (Table of Contents) area
when the MD recorder ejects the disc, enters
stand-by mode, or stops recording.
Do not disconnect the power cable or move the
unit under the following circumstances.
Otherwise, the information will not be written
correctly.
• The TOC indicator is lit.

The information to be written into the MD’s
TOC area is currently stored in the recorder’s
memory.

The recorder is now writing the information in
the MD’s TOC area.

The TOC indicator appears as recording
starts.
The MD recorder will automatically stop
when recordable time on the disc expires.
The tracks are automatically numbered.
(Level Sync function)

Since the interval between tracks is
detected based on the sound level, some
tracks may not be numbered correctly in
the following cases:
• The recorded condition of the cassette

tape is bad (noise between tracks).

• There is a low sound level in quiet

music.

• The interval between tracks is extremely

short.

• The tuner's reception is poor (noisy).

To disable the Level Sync function, refer to
“Using the Level Sync function” on page 29.

MINIDISC RECORDER 

STANDBY

CD

INPUT

DUBBING

PUSH TO ENTER

(

)

AMCS

DISPLAY

EDIT / NO

YES

REC

STANDBY / ON

MD-

105TX

REC MODE

REC