Roland Fantom-X8 Manual Do Utilizador

 

If the Fantom-X does not function in the way you expect, first check 
the following points. If this does not resolve the problem, consult 
your dealer or a nearby Roland Service Station.

 

The power does not turn on.

Make sure that the Fantom-X’s AC cord is connected correctly 

Turning the VOLUME knob doesn’t change the volume.

If you’re using the DIGITAL OUT, the VOLUME knob will not 

There is no sound.

Check the following points.

• Is the power for connected amps and speakers turned on? Is the 

volume turned all the way down?

• Is the VOLUME knob turned all the way down?

• Have connections been made correctly?

• Can you hear sound through headphones?

If there is sound in the headphones, it is possible that the 
connection cables are broken, or that your amp/mixer has 
malfunctioned. Check your cables and amp/mixer system once 
again.

• If you do not hear sound when you play the keyboard, check 

whether the Local Switch is turned OFF.

• Have all tones in the patch been turned off?

Turn on “Tone Switch.”

• The Part level settings may be too low. 

• Are the Effect settings correct?

Check the Effect settings ON or OFF, the Effect Balance or 
Level. (p. 206)]

• Are the settings for the output destination correct?

• Is the Wave Expansion Board properly installed?

When selecting the settings that stipulate the use of EXP-A–D 
waves, Patches, or Rhythm Sets, check that the specified Wave 
Expansion Board is installed properly in the specified slot (p. 
240, p. 242). 

• Has the volume been lowered by pedal operations or by MIDI 

messages (volume messages or expression messages) received 
from an external MIDI device?

 

In the case of Performance mode, the value of volume messages 
(Volume) and expression messages (Expression) can be viewed 
in the Part Information window (p. 106).

• Have the samples been loaded correctly? (p. 201)

A specific Part does not sound

Check the following points.

• Has the volume level of the part been lowered?

Adjust the Level parameter to raise the volume of the part that 
is not heard (p. 108).

• Is the part being muted?

Specific pitch ranges do not sound

Has a restricted range of notes been set?

If a specific range of notes does not sound, check the Key Range 
settings for the Patch Tone, the Performance Part.

•

 

•

 

The sound is distorted.

Check the following points.

• Is an effect which distorts the sound being applied?

If the sound for a specific patch or part is distorted, lower the 
volume level on that part.

• If all sounds are distorted, use the VOLUME knob to lower the 

volume level.

• Could the Output Gain be excessively high?

In “System,” check the “Sound” parameter.

Pitch is incorrect.

Check the following points.

• Is the tuning of the Fantom-X incorrect?

• Has the pitch been changed by pedal operations or by Pitch 

Bend messages received from an external MIDI device?

 

In the case of Performance mode, the value of Pitch Bend 
messages (Pitch Bend) can be viewed in the Part Information 
window (p. 106).

• Have the Coarse Tune or Fine Tune parameters been set for 

specific Parts?

Check the Coarse Tune parameter and Fine Tune parameter 
settings (p. 109).

Fantom-X678_r_e.book 249 ページ ２００５年５月１２日　木曜日　午後４時４０分