Roland Fantom-X8 Manual Do Utilizador

Creating a Patch

●

Changing the TVF Envelope

TVA ENV A-TIME:

Changes the Env Time 1 parameter of the
TVA envelope.

TVA ENV D-TIME:

Changes the Env Time 2 and Env Time 3
parameters of the TVA envelope.

TVA ENV R-TIME:

Changes the Env Time 4 parameter of the
TVA envelope.

●

Splitting Tones That Are Played

TMT

If the Matrix Control is used to split tones, set the TMT Vel
Control parameter to “OFF,” and the TMT Control Switch
parameter to “ON” (p. 66, p. 66).

• If the Matrix Control is used to split tones, we recommend

setting the Matrix Control Sens to “+63.” Selecting a lower value
may prevent switching of the tones. Furthermore, if you want to
reverse the effect, set the value to “-63.”

• If you want to use matrix control to switch smoothly between

tones, use the Velo Fade Lower and Velo Fade Upper
parameters (p. 66). The higher the values set, the smoother the
switch is between the tones.

●

Changing the Depth of Frequency
Modulation for FXM

FXM DEPTH

●

Controlling the amount of realtime stretch/
shrink

TIME

This will have no effect if Realtime Time Stretch (p. 63) is not
selected. If matrix control sensitivity is set to “+” the stretch/
shrink time will become shorter, and if set to “-” the time will
become longer.

●

Changing Specific Multi-Effects Parameters

MFX CTRL1–4:

Change the parameter that was specified by
MFX Control 1–4 Assign parameter.

If you have not made the necessary settings for using the multi-
effect, the multi-effect will not be applied even if you attempt to
control it as a Matrix Control destination.

●

If you’re not using Matrix Control

OFF:

Matrix Control will not be used.

CTRL Sens 1–4 (Matrix Control Sens 1–4)

Sets the amount of the Matrix Control’s effect that is applied. If you
wish to modify the selected parameter in a positive (+) direction –
i.e., a higher value, toward the right, or faster etc. – from its current
setting, select a positive (+) value. If you wish to modify the selected
parameter in a negative (-) direction – i.e., a lower value, toward the
left, or slower etc. – from its current setting, select a negative (-)
value. For either positive or negative settings, greater absolute
values will allow greater amounts of change. Set this to “0” if you
don't want to apply the effect.

Value:

-63– +63

CTRL Tone 1–4 (Tone Control Switch 1–4)

Matrix Control Tone selects the tone to which the effect is applied
when using the Matrix Control.

Value

OFF:

The effect will not be applied.

ON:

The effect will be applied.

REVS:

The effect will be applied in reverse.

For details regarding effect settings, refer to the pages shown
below.