Intex Recreation 634 Manual Do Utilizador

(110)  MODEL 634 FILTER PUMP  ENGLISH  7.5” X 10.5” PANTONE 295U  01/31/2007

FILTER MOTOR 
FAILS TO START

FILTER DOESN’T
CLEAN POOL

FILTER DOESN’T
PUMP WATER OR
FLOW IS VERY
SLOW

PUMP DOESN’T
WORK

TOP COVER 
LEAKING

HOSE LEAKING

AIR LOCK

• Not plugged in.
• Fuse box needs checking.
• GFCI/RCD circuit breaker 

tripped.

• Improper chlorine or pH 

levels.

• Filter cartridge dirty.
• Cartridge damaged.
• Excessively dirty pool.
• Strainer screen restricting 

flow.

• Inlet/discharge clogged.
• Air leak on intake line.
• Scale or buildup on cartridge.
• Excessively dirty pool.
• Filter cartridge dirty.

• Low water level.
• Strainer screen plugged up.
• Air leak on intake hose.
• Faulty motor or impeller 

jammed.

• Air lock inside cartridge 

chamber.

• O-ring missing.
• Cover not tight.
• Filter cartridge dirty.

• Hose nuts.

• Pump housing and inlet hose 

air trapped.

•  Inlet and outlet hoses 

connection reversed.

• Filter cord must be plugged into a 3 wire 

outlet that is protected by a Class A 
Ground Fault Circuit Interrupter, or RCD.

• Reset circuit breaker. If circuit breaker

trips repeatedly, your electrical system 
may have a defect. Turn off circuit 
breaker and call an electrician to 
correct the problem.

• Motor too hot and overload protection 

shut motor off. Let motor cool down.

• Adjust chlorine and pH level. Consult 

your local swimming pool supply stores.

• Clean or replace cartridge.
• Check for holes in cartridge. Replace 

if damaged.

• Operate filter for longer periods.
• Clean strainer screen at pool wall inlet.

• Look for obstructions in intake hose or 

discharge hose inside pool wall.

• Tighten hose nuts, check hoses for

damage, check pool water level.

• Replace cartridge.
• Clean cartridge more often.
• Clean inside plunger valve.
• Pull valve handle to full upright position.

• Fill pool to correct water level.
• Clean strainer screens at pool inlet.
• Tighten hose nuts, check hose for damage.
• Check & clear any sticks or leaves in 

intake to pump.

• Turn & pull valve handle to full upright 

position.

• Remove cover & check for O-ring.
• Tighten cover (Manually).
• Replace or clean cartridge.

• Tighten/reinstall hose nut.

• Open air release valves, wait until water 

starts to flow out of the air release 
valves, close air release valves.

• Lower position of pool outlet connect 

to filter pump water inlet, upper 
position of pool inlet connect to filter 
pump water outlet.