Black & Decker F-042-PRKK Manual Do Utilizador

Thank you for purchasing this Price Pfi ster Lavatory Faucet.  All Price Pfi ster products are carefully engineered and factory tested to provide 
long trouble-free use under normal conditions. This Lavatory Faucet is easy to install using basic tools and our easy to follow illustrated 
instructions. If you have any questions regarding your Lavatory Faucet installation, call 1-800-Pfaucet (1-800-732-8238).

  WARNING: Read all the instructions completely before proceeding. 

Price Pfi ster recommends calling a professional if you are uncertain about 

installing this product!

This product should be installed in accordance with all local and state plumbing and 
building codes.

Locate water supply inlets and shut off the water supply valves. These are 

usually found under the sink or near the water meter. If you are replacing an 

existing faucet, remove the faucet from the sink and clean the sink surface 

thoroughly.

• PTFE plumber's tape or thread sealant            • Plumber's putty

• Slotted screwdriver • Phillips head screwdriver 

• Pliers 

 

• Adjustable wrench • Flashlight 

 

• Cloth

Your installation may require supply lines and/or shut-off valves, cone washers,  

friction rings, or other additional tools. Consult the store where your faucet was 

purchased for recommended connections that may be required for you area.

Assemble Base Washer (4A1) to Faucet Body (4A2). With the handle and 

spout facing forward, carefully install the Faucet Supply Tubes (4A3) through 

the center hole of sink (4A4).

Ensure that the Plastic Putty Plate (4B1) is pressed on the Deckplate (4B2).  

Place a bead of plumber’s putty in the groove along the outer edge of the Putty 

Plate (4B1). Assemble Deckplate and Putty Plate to Faucet Body (4B3). With 

the handle and spout facing forward, carefully install the Faucet Supply Tubes 

(4B4) through the center hole of sink (4B5).

Ensure that the Plastic Putty Plate (4C1) is pressed on the Deckplate (4C2).  

Place a bead of plumber’s putty in the groove along the outer edge of the Putty 

Plate (4C1). Assemble Deckplate and Putty Plate to Faucet Body (4C3). With 

the handle and spout facing forward, carefully install the Faucet Supply Tubes 

(4C4) through the center hole of sink (4C5).

From underneath sink, secure the faucet by placing the Metal Washer (5A) 

and the Long Nut (5B) (

7

/

16

 hex.) onto the Mounting Post (5C). Make sure 

that the bumps on the Metal Washer (5A) are facing up. Tighten using a fl athead 

screwdriver or an adjustable wrench until the faucet is fi rmly connected to the 

sink. Secure connection by screwing the Setscrew (5D) onto the Long Nut

(5B). Do not over tighten!

2

ENGLISH

4A1

4A3

4A2

4A4

5A

5C

5B

5D

4B3

4B4

4B5

4B2

4B1

4C3

4C4

4C5

4C2

4C1