Black & Decker F-042-PRKK Manual Do Utilizador

Thread the ½” NPSM Adapter (6A) into the ⅝” Nut (6B). Tighten using 

wrenches on both the Adapter and the Nut. Make connection to the Faucet 

Inlet (6C). Repeat for the other tube. Connect water Supply Lines (6D) to 

Faucet Inlets (6C).  (Supply lines and fi ttings are not included).

Insert threaded Shank (7A) of soap dispenser body through Rubber Gasket 

(7B) and sink hole. Tighten Nut (7C) and thread on Bottle (7D) to Shank (7A).

Pour liquid soap (not included) into the Shank Opening (8A). Install Dispenser 

Mechanism (8B) into Dispenser Head(8D). Insert Dispenser Head (8D) and 

Dispenser Mechanism (8B) into Soap Dispenser Body (8C).

Insert Lift Rod (9A) into hole at the back of Spout Hub (9B). Gently, slide Lift 

Rod (9A) down the hole in Spout Hub (9B).

Apply a small bead of plumber’s putty underneath the Flange (10A) and place 

a ring of putty around Drain Opening (10B) of sink. Use PTFE plumber’s tape 

on all threaded fi ttings according to  manufacturer’s instructions. Insert Flange 

(10A) into Drain Opening (10B). From underneath, thread  Drain Body (10C) to 

bottom of Flange (10A). Thread Locknut (10D) until Rubber Washer (10E) seats 

securely inside Drain Opening (10B). Hand tighten and adjust the Drain Body 

so that the Ball Rod Opening (10F) faces the rear. Wipe excess putty.

3

ENGLISH

6A

6B

6D

6C

8B

8A

8C

8D

8D

8C

9A

9B

10A

10B

10C

10D

10F

10E

7A

7B

7D

7C