Yamaha RX-V3800 Manual Do Utilizador
114
En
Remote control features
You can clear all changes made in each function set, such
as learned functions, macros, renamed input area names
and setup remote control ID.
as learned functions, macros, renamed input area names
and setup remote control ID.
■
Clearing function sets
1
Set the operation mode selector to
D
AMP
or
D
SOURCE
and then press
M
CLEAR
by
using a ballpoint pen or similar object.
“CLEAR” appears in the display window (B).
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, start over from step 1.
seconds, the clearing mode will be automatically canceled.
In this case, start over from step 1.
2
Press
4k
/
n
to select the clear mode.
L;CD (etc.) (L; Name of an input area) Clears all learned
functions in the respective input area. The name
of a component is shown after a semicolon (;).
Press an input selector button to select the input
area.
of a component is shown after a semicolon (;).
Press an input selector button to select the input
area.
L;AMP
Clears all learned functions for controlling the
amplifier functions of this unit.
amplifier functions of this unit.
L;ALL
Clears all learned functions.
M;ALL
Clears all programmed macros.
RNAME
Clears all renamed source names.
FCTRY
Clears all remote functions and returns the
remote to the factory settings.
remote to the factory settings.
3
Press and hold
M
CLEAR
again for about 3
seconds.
“WAIT” appears in the display window (B). If
clearing was successful, “C;OK” appears in the
display window (B) on the remote control.
clearing was successful, “C;OK” appears in the
display window (B) on the remote control.
y
Once you have cleared a learned function for a button, the button
reverts to the factory setting (or to the manufacturer setting, if you
have set remote control codes).
Once you have cleared a learned function for a button, the button
reverts to the factory setting (or to the manufacturer setting, if you
have set remote control codes).
• “L;ALL” and “FCTRY” may take about 30 seconds to
complete.
• “C;NG” appears in the display window (B) if clearing was
unsuccessful. In this case start over from step 2.
• “ERROR” appears in the display window (B) if you press a
button not indicated in the respective step, or if you press more
than one button simultaneously.
than one button simultaneously.
4
Press
M
CLEAR
again to exit.
Clearing configurations
Note
CLEAR
TV
SOURCE
AMP
TV
SOURCE
AMP
or
A-E/CAT.
PRESET/CH
ENTER
Notes
CLEAR