ONKYO TX-SR8370 Manual Do Utilizador

 

93

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 49).
• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

 

• Channels cannot be selected while the 

 indica-

tor is flashing, as tuning is in progress.

 

• Make sure that the batteries are installed with the cor-

rect polarity (page 13).

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 13).

• Make sure you’ve selected the correct remote control-

ler mode (page 14).

• Make sure you’ve entered the correct remote control 

code (page 86).

 

• Make sure you’ve selected the correct remote control-

ler mode (page 14).

• If you’ve connected an 

-capable Onkyo MD 

recorder, CD recorder, or next generation HDD-com-
patible component to the TAPE IN/OUT jacks, or a 
DS-A1 Remote Interactive Dock to the VIDEO 3 IN 
jacks, for the remote controller to work properly, you 
must set the input display to MD, CDR, or HDD (see 
page 46).

• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• If none of the codes work, use the Learning function 

to learn the commands of the other component’s 
remote controller (page 89).

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control an Onkyo component that’s connected via 

, point the remote controller at the AV receiver. Be 

sure to enter the appropriate remote control code first 
(page 87).

• To control an Onkyo component that’s not connected 

via 

, or another manufacturer’s component, point 

the remote controller at the component. Be sure to 
enter the appropriate remote control code first 
(page 86).

 

• When learning commands, make sure that the trans-

mitting ends of both remote controllers are pointing at 
each other.

• Are you trying to learn from a remote controller that 

cannot be used for learning? Some commands cannot 
be learned, especially those that contain several 
instructions.

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT, 
VIDEO 1 IN to VIDEO 1 OUT, or VIDEO 2 IN to 
VIDEO 2 OUT).

• When the Pure Audio listening mode is selected, video 

recording is not possible because no video signals are 
output. Select another listening mode.

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio, in which case it stays the 
same.

 

• Use the “Multiplex” setting on the “Audio Adjust” 

menus to select “Main” or “Sub” (page 68).

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 35).

• While Zone 2 is on, the 

 functions do not work.

 

• The display is turned off when the Pure Audio listen-

ing mode is selected.

TX-SR803_En.book Page 93 Friday, August 26, 2005 9:26 AM